eSATA II 2 Port ExpressCard
User Manual
Model P-NSA2-EC-RF
Ver. 1.0
All brand names and trademarks are properties of their
Respective owners.
Aug/07
1
MN7036400002
Hardware Description
Hardware Installation
1. Insert the Card into the ExpressCard slot of your system.
2. Make sure the card is securely inserted.
Aug/07
3
MN7036400002
Driver Installation
For Windows® XP/Server 2003
1. At the Found New Hardware Wizard:
XP(w/SP1 or earlier)/Server 2003: continue to step #2
XP(w/SP2 or later)/Server 2003(w/SP1 or later): select No, not
this time, then click Next.
2. Please insert the provided driver CD into your CD-ROM Drive,
select Install the software automatically (Recommended), and
click Next.
3. Accept the default entry, then click Next.
4. Click Finish.
5. Restart Windows to complete the installation.
For Windows® Vista
1. At the Found New Hardware Wizard window pop-up, please
select Locate and install drier software (recommended) to start
the installation.
2. Please insert the provided driver CD into your CD-ROM Drive.
3. Click on Close to complete the driver installation.
4. Restart Windows to complete the installation.
Aug/07
4
MN7036400002
For Windows® 2000
1. At the Found New Hardware Wizard, click Next.
2. Select Search for
a
suitable driver for my device
(recommended), then click Next.
3. Please insert the provided driver CD into your CD-ROM Drive,
check CD-ROM drives, uncheck the other boxes, click Next,
then click Next again.
4. If the Digital Signature Not Found message appears, click Yes.
Our driver has been thoroughly tested for stability and
compatibility.
5. Click Next, then Finish.
6. Restart Windows to complete the installation.
To Verify Windows® Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Double click SCSI and RAID Controller, then double click
Silicon Image SiI 3132 SATALink Controller to display driver
properties. A message this device is working properly is
Aug/07
5
MN7036400002
displayed in the dialog box, the driver has been correctly installed.
Hot-Plugging Hard Disk Drives
To remove a drive from a powered up system, do the following:
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Click Disk Drives, right click the target disk and select
Disable/Enable.
4. You can now remove the target disk.
1 Year Warranty
Free Technical Support: 1-800-234-4597
Aug/07
6
MN7036400002
|